Erase Fault Codes - Vehicletool Mini VAG505A Manual

Mini VAG505A/VAG506M/VAG506/V801
As seen on the top right corner, the front digit is the No. of the displayed
fault code, while latter digit is the number of total fault codes.
.
2 If more than one DTC is found, use the [down] key to read the next
page, press [up] key for the previous page.

If no data is recorded, a message "There is no codes in the vehicle!"
shows on the screen.

2.7 Erase fault codes

CAUTION: Erasing the Diagnostic Trouble Codes may allow the
scan tool to delete not only the codes from the vehicle's on-board
computer, but also "Freeze Frame" data and manufacturer specific
enhanced data. Further, the I/M Readiness Monitor Status for all
vehicle monitors is reset to Not Ready or Not Complete status. Do
not erase the codes before the system has been checked
completely by a technician.
NOTE: Erasing codes does not mean that trouble codes in
ECU have been eliminated completely. As long as there is fault
with the vehicle, the trouble codes keeps on presenting.
 This function is performed with key on engine off (KOEO). Do
not start the engine.
1. Use the UP/DOWN scroll button to select 05-Clear Codes from
Function menu (Figure 2.4), and press ENTER button, a message
will come up asking you to confirm the ignition and engine status. If
you select "Yes", a warning message will come up asking your
confirmation.
2. If you do wish to erase the codes, use LEFT/RIGHT scroll button to
check YES, then press ENTER button.

10