Sharp Cooktop Installation Manual page 5

C
INSTALL THE STOP SCREWS
Confirm all cut-out openings and clearances as
IMPORTANT
indicated on page 2 before installing the appliance. These two
stop screws prevent the appliance from sliding out of position during
operation. Attach the stop screws (supplied in the screw bag) to the
right and left sides of the cabinet opening as specified. See Figure
10. Use a 1/16" drill bit to pre-drill holes.
Figure 10
Do not lift or move this appliance by the
D
IMPORTANT
Microwave Drawer handle.
POSITION THE APPLIANCE IN FRONT OF THE OPENING
AND PLACE THE ELECTRICAL CONDUIT CLOSE TO THE
LOCATION OF THE JUNCTION BOX.
If needed, drill a 1" hole in the cabinet side or bottom to allow
the conduit access to the junction box. DO NOT CONNECT until
installation of the appliance is complete in the cabinet.
E
PLACE THE APPLIANCE INTO OPENING
It is suggested that two people lift the appliance into place, carefully
setting the side metal flanges under the cooktop glass on the edges of
the countertop opening. Check that the appliance clears the cabinet
face frame. Tilt the appliance as you slide it back so that it will clear.
The unit will have to be pushed in until the front feet are behind the
cabinet face frame. See Figure 11.
Figure 11
2 1/4"
from
13 7/8"
front edge of
from top of
countertop
counter
stop screw locations
INSTALLATION MANUAL
F
PUSH THE UNIT BACK UNTIL IT HITS THE STOP
SCREWS INSTALLED IN STEP "C"
Stop screw
installed
in step "C"
Figure 12
G
LIFT THE FRONT OF THE UNIT UP SLIGHTLY (ABOUT
1/2") AND PUSH BACK UNTIL THE SLOTS ON THE
MOUNTING BRACKET ENGAGE THE STOP SCREWS.
See Figure 13.
Figure 13
H
LOWER THE APPLIANCE UNTIL IT RESTS ON THE
COUNTERTOP.
Confirm that the slots on the mounting bracket have engaged the
stop screws. See Figure 14.
Figure 14
If the cooktop does not fit properly on the counter top, the mount-
ing bracket may not be positioned properly on the stop screws. To
correct, slide the appliance out one inch and follow instructions
from above.
F
5
See Figure 12.