Sharp SCH2443GB Installation Manual

Sharp SCH2443GB Installation Manual

Hide thumbs Also See for SCH2443GB:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Induction Cooktop: SCH2443GB, SCH3043GB
SPECIAL WARNING
• INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
• IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR'S USE.
• READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IMPORTANT NOTES TO THE INSTALLER
• Read the entire Installation Manual before installing the Induction
Cooktop.
• Remove all packing material before connecting the electrical
supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
• All cooktops must be hard wired (direct wired) into an approved
junction box. A plug-in outlet is not permitted on these products.
IMPORTANT SAFETY INSTRUCTIONS
Failure to follow the safety and installation
WARNING
instructions in this manual may result in fire or electric shock that
could cause property damage, personal injury or death.
Never leave children alone or unattended in the
WARNING
area where a cooktop is in use.
Stepping, leaning or sitting on the cooktop may
WARNING
result in serious injury and damage to the cooktop.
Do not store or use gasoline or other flammable
WARNING
vapors and liquids in the vicinity of this or any other appliance.
Cabinets located above the radiant unit may burn
WARNING
or ignite due to overheating. Reduce the risk of burns and fire by
installing a range hood that protects horizontally at a minimum of 5
inches below the bottom of the cabinets.
Provide sufficient space around the cooking area to
CAUTION
prevent accidents and achieve optimal ventilation.
IMPORTANT INSTALLATION INFORMATION
• Dimensions shown on page 3 and 4 must be used.
dimensions provide minimum clearance.
• Contact surface must be solid and level.
• The approximate location of the junction box should be a
minimum of 12" (30.5 cm) below the cooktop. See Figure 5.
• Your cooktop can be installed into a countertop by itself, above
a gas or electric wall oven, above a microwave drawer or above
a convection microwave drawer.
• All induction cooktops run off a single phase, three-wire cable,
208/240V/30A 60Hz, AC only electrical supply with ground.
Minimum distance between cooktop and overhead cabinetry
0".
is 3
INSTALLATION MANUAL
Given
PART INCLUDED
PARTS
Cushion Tape # PCUSGB125MRP0
77 cm x 6 mm x 2 mm
Cushion Tape # PCUSGB126MRP0
54 cm x 6 mm x 2 mm
BEFORE INSTALLING THE COOKTOP
1. Visually inspect the cooktop for damage. Ensure all cooktop
screws are on tight.
2. Record the model and serial number as found on the bottom of
your cooktop. When ordering parts for or making inquiries about
your cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate on your
cooktop.
3. Prepare the cutout dimensions of the countertop.
4. Make sure the wall coverings, countertop and cabinets around
the cooktop can withstand heat (up to 200°F) generated by the
cooktop. It is very important to allow sufficient space under
the cooktop. If under the cooktop has insufficient space, the
temperature may become too high and affect performance. See
Figure 6.
5. Apply the included cushion tape around the outer edge of the
glass on all four sides. Do not overlap the tape. See Figure 1.
6. Gently lower the cooktop into the countertop cutout.
NOTE: Do not seal the cooktop to the countertop. The cooktop must
be removable if service is necessary. Remove all packaging labels
and protective film before operating the induction cooktop.
Bottom of Cooktop
Cooktop
Glass
1
1
Foam Tape
Figure 1
QTY.
2
2
E

Advertisement

Table of Contents
loading

Summary of Contents for Sharp SCH2443GB

  • Page 1 Induction Cooktop: SCH2443GB, SCH3043GB INSTALLATION MANUAL SPECIAL WARNING • INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. • IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR’S USE. • READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. IMPORTANT NOTES TO THE INSTALLER PART INCLUDED •...
  • Page 2: Electrical Connection

    ELECTRICAL CONNECTION The Induction Cooktop must connect to a separate, single phase, AC only electrical supply with its own circuit breaker. This appliance Cable from Power Supply must be installed in accordance with National Electrical Codes, as well as all state, municipal and local codes. This appliance must be supplied with the proper voltage and frequency and amperage, which Red Wire is protected by a properly sized circuit breaker or time delay fuse.
  • Page 3 INSTALLATION – 30" MODEL SCH3043GB COOKTOP AND CUTOUT DIMENSIONS A. 30" (76.2 cm) B. 21" (53.3 cm) 30” (76.2 cm) min. for cabinet " (5 mm) *Do not obstruct these areas. D. 2 " (6.8 cm) E. 29 " (74.1 cm) F.
  • Page 4 INSTALLATION – 24" MODEL SCH2443GB COOKTOP AND CUTOUT DIMENSIONS 30” (76.2 cm) min. for cabinet A. 24" (61 cm) *Do not obstruct these areas. B. 21" (53.3 cm) " (5 mm) D. 2 " (6.8 cm) E. 22 " (56.7 cm) F.
  • Page 5: After Installation

    NOTE: If the coo ktop does not operate, first check to see if the circuit breaker has tripped or a fuse has blown. ation, see Before You Call for Service in the For more inform operation manual. Contact us at 1-800-BE-SHARP for assistance or service.
  • Page 6 SHARP ELECTRONICS CORPORATION • 100 Paragon Drive • Montvale, New Jersey 07645 • USA SHARP ELECTRONICS OF CANADA LTD • 335 Britannia Road East • Mississauga, Ontario • L4Z 1W9 • Canada...
  • Page 7: Manuel D'installation

    Surface de cuisson : SCH3043GB, SCH2443GB MANUEL D'INSTALLATION • Vérifier que l'emplacement où la surface de cuisson sera installée dispose de l'alimentation électrique appropriée. Emplacement AVERTISSEMENT SPÉCIAL approximatif de la boîte de jonction, 30,5 cm (12 po) minimum sous la surface de cuisson. Voir la figure 4.
  • Page 8: Branchement Électrique

    BRANCHEMENT ÉLECTRIQUE Les surfaces de cuisson à induction doivent être branchées à une Câble de l'alimentation électrique source d'alimentation électrique CA seulement, monophasée et séparée, équipée de son propre disjoncteur. Ces appareils doivent être installés conformément aux codes de l'électricité nationaux, provinciaux, municipaux et locaux.
  • Page 9 INSTALLATION – MODÈLES DE 76,2 CM (30 PO) SCH3043GB DIMENSIONS DE LA SURFACE DE CUISSON ET DE LA DÉCOUPE A. 76,2 cm (30 po) B. 53,3 cm (21 po) 30” (76.2 cm) min. for cabinet C. 5 mm ( Minimum 76,2 cm (30 po) pour l'armoire *Do not obstruct these areas.
  • Page 10 INSTALLATION – MODÈLES DE 61 CM (24 PO) SCH2443GB DIMENSIONS DE LA SURFACE DE CUISSON ET DE LA DÉCOUPE 30” (76.2 cm) min. for cabinet Minimum 76,2 cm (30 po) pour l'armoire A. 61 cm (24 po) *Do not obstruct these areas.
  • Page 11: Après L'installation

    APRÈS L'INSTALLATION 1. Retirer tous les autocollants et les articles sur le dessus de la surface de cuisson. 2. Nettoyer la surface de cuisson avant de l'utiliser. Essuyer à l'aide d'un chiffon doux. Voir les consignes de nettoyage et d'entretien dans le manuel d'utilisation en guise de référence.
  • Page 12 SHARP ÉLECTRONIQUE DU CANADA LTÉE • 335, rue Britannia Est • Mississauga, Ontario • L4Z 1W9 • Canada TINSEB 5 9 0 Mr r0 Apr 28, 2022...

This manual is also suitable for:

Sch3043gb

Table of Contents