Table of Contents
Advertisement
Quick Links
SPECIAL WARNING
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL
INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CLEARANCES & DIMENSIONS
For SAFETY CONSIDERATIONS do not install a appliance in any combustible cabinetry which is not
in accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.
APPLIANCE MEASUREMENTS .................................2
CLEARANCES AND DIMENSIONS ..............................2
IMPORTANT NOTES .............................................3
UNPACKING AND EXAMINING YOUR APPLIANCE ...........3
IMPORTANT SAFETY INSTRUCTIONS .........................3
INSTALLATION, ANTI-TIP ................................... 4-6
INSTALLATION MANUAL
CHECKING INSTALLATION ......................................6
ELECTRICAL CONNECTIONS ...................................6
POWER CONNECTIONS .........................................7
MODEL AND SERIAL NUMBER LOCATION ....................8
CARE, CLEANING AND MAINTENANCE ......................8
BEFORE YOU CALL FOR SERVICE ............................8
Advertisement
Table of Contents
Related Manuals for Sharp Cooktop
Summary of Contents for Sharp Cooktop
-
Page 1: Table Of Contents
INSTALLATION MANUAL SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. CLEARANCES & DIMENSIONS For SAFETY CONSIDERATIONS do not install a appliance in any combustible cabinetry which is not in accord with the stated clearances and dimensions on page 2. -
Page 2: Appliance Measurements
Figure 3 To eliminate the risk of burns or fi re by reaching over the cooktop, cabinet storage space located above the cooktop should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5”... -
Page 3: Important Notes
• Be sure your appliance is installed and grounded properly by a qualifi ed installer or service technician. See page 7. • To eliminate the need to reach over the cooktop, cabinet storage space above the cooktop should be avoided or a range hood installed. -
Page 4: Installation, Anti-Tip
Measure the thickness of the counter. See Figure 7. Locate the Anti-Tip Bracket on the backside of the appliance. See Figure 8. Loosen screws and adjust space between the glass cooktop and bracket to match the counter thickness plus 1/16”. See Figure 9. - Page 5 PLACE THE APPLIANCE INTO OPENING It is suggested that two people lift the appliance into place, carefully setting the side metal flanges under the cooktop glass on the edges of the countertop opening. Check that the appliance clears the cabinet face frame.
-
Page 6: Checking Installation
INSTALLATION MANUAL MAKE SURE THE EDGE OF THE COUNTERTOP FITS FLUSH AGAINST THE END OF THE FRONT CONTROL See Figure 15. PANEL. Figure 15 CHECKING INSTALLATION To check if the device is installed and engaged properly, open the Microwave Drawer fully and gently apply medium force in the center of the handle until movement of the appliance is detected. -
Page 7: Power Connections
POWER CONNECTIONS This appliance is manufactured with a neutral (white) power supply wire and a cabinet-connected green grounding wire. Connect the appliance cable to the junction box through the UL- listed conduit connector. Complete electrical connection according to local codes and ordinances. For preferred junction box location, see Figure 2, page 2. -
Page 8: Model And Serial Number Location
Refer to the warranty in your Operation Manual for our toll-free service number and address. Please call or write if you have inquiries about your appliance product and/or need to order parts. SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 PRINTED IN USA...