Zone Edit; Midi Settings; Controls Mapping - Studiologic SL Mixface User Manual

Zone Edit

1. Rotate the Encoder to select one of the 4 Zones,
shown on the display and press IN;
2. Once the Zone is selected, the submenu allows you
to enable the Zone, set its MIDI settings and map the
controls available on the panel.

MIDI Settings

The page related to MIDI Settings allows you to set the
following parameters:
•
Port: (USB Host, USB Device, Bluetooth);
•
MIDI Ch (MIDI channel);
•
PRG (Program Change) that is sent to the Mixface
Program selection;
•
Bank select (MSB + LSB);
•
Key range (Lower and Upper);
•
Transpose;
•
Octave.
Turn the Encoder to scroll through the parameters of
the left column; once the desired parameter has been
selected, press on the Encoder to move the focus to
the right column and set the desired value.
NOTE
These parameters are ignored in SL KEYBOARD mode,
because Mixface extends the Zones of a SL MIDI
Controller.
11
SL Mixface by Studiologic®

Controls mapping

The "Controls Mapping" editing section allows
programming of all Mixface controllers (sliders,
potentiometers and buttons) for each of the 4 Zones.
Mixface provides the user with two complete sets of
control surfaces for a total of 18 sliders (8x2 + 2 master),
16 buttons, 16 rotary sliders.
In the example picture, a Control Change 16 is assigned
to the Slider 1:
From the MIDI message assignment screen, by clicking
on the "OUT" button, you go back to the editing page
structure and you can then activate a second physical
control of Mixface (for example Slider 2) for the related
assignment.
In this way you can assign two sets of 9 sliders, 8 rotary
sliders and 8 buttons with a total of 50 MIDI controls
for each Zone in Controller mode.
Choose the set of controls
to program;
Operate the physical
control you want to
program (press a button,
rotate a potentiometer o
move a slider);
Once the Mixface control
has been selected, the
page for assigning the
MIDI message is shown.