General Connection (Poe); Network Connection - Cisco 8020 Reference Manual

Network Deployment

General Connection (PoE)

Using a PoE-Enabled Switch
The camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable.
Figure 1-4
Figure 1-4
Using a Non-PoE Switch
Use a PoE power injector (optional) to connect between the camera and a non-PoE switch, as shown in
Figure
Figure 1-5
Note •
•

Network Connection

Internet Connection via a Router
To set up the camera over the Internet, make sure you have a router and follow these steps:
Connect your camera behind a router, the Internet environment is illustrated in
Step 1
Cisco Video Surveillance 8020/8030 IP Camera Reference Guide
1-16
illustrates how to connect the camera to a PoE-enabled switch via an Ethernet cable.
Connecting the Camera to a PoE-Enabled Switch
1-5.
Connecting the Camera to a Non-PoE Switch
The camera is only to be connected to PoE networks without routing to outside plants.
For a PoE connection, use only UL listed I.T.E. with PoE output.
Chapter 1 Getting Started
Figure 1-6.