Makita AN610H Instruction Manual page 8

Construction nailer
Hide thumbs Also See for AN610H:
Table of Contents

Advertisement

Available languages

Available languages

1
► 1. Nail driven to a proper depth 2. Nail driven too
deep will cause deformation of workpieces
CAUTION:
Depending on the hardness and total thickness
of all workpiece in combination to be fastened,
enough fastening may not be obtained. Nailing
on steel plate to excessive depth may extremely
reduce the fastening force. Before nailing,
adjust the nailing depth properly.
In the nailing on the steel plate, the driver may
be clogged due to susceptibility to wear. When it
is worn, sharpen it or replace it with a new one.
Nailing of concrete
WARNING:
Use hardened nails only for concrete.
Using other purposed nails may cause serious
injuries.Do not nail directly on the concrete or do
not use to fasten directly the steel plate to the
concrete. Failure to do so may cause concrete
fragments to fly off or nails to strike back, caus-
ing serious injuries.
When nailing, hold the tool so that it stands
upright to the driving surface.
Slanted nailing may cause concrete fragments
to fly off or nails to strike back, causing serious
injuries.
Do not use on the surface that objects hang
from, such as area where hangers for sewer
pipe, dust pipe etc. are set up
Choose and use nails so that the penetration amount
into concrete ranges 10 mm (3/8") - 15 mm (5/8") by
referring to the table below.
Wood thickness
Nail length
(mm)
20(3/4")
32(1-1/4")
25(1")
38(1-1/2")
30(1-3/16")
45(1-3/4")
35(1-3/8")
2
Concrete
(mm)
(mm)
Approx. 12(1/2")
Approx. 13(1/2")
Approx. 15(5/8")
50(2")
Approx. 15(5/8")
1
► 1. Nail length 2. Wood thickness 3. Concrete range
10 mm (3/8") - 15 mm (5/8")
CAUTION:
Use this tool only for soft concrete built up not
so long before. Using on the hard concrete
may cause nail bending or nailing to insufficient
depth.
When the penetration amount into concrete
comes to more than 15 mm (5/8"), nailing to the
sufficient length may not be obtained.
Cutting off the sheet
CAUTION:
Always disconnect the hose before cutting off
the sheet.
Tear off the output sheet in the direction of the arrow
when using the sheet collated nails.
8 ENGLISH
2
3

Advertisement

Table of Contents
loading

Table of Contents