Table of Contents
Advertisement
Separate the electronics from the mechanical part.
Install and mechanically tighten in the vessel, and
tighten depending on the thread type and size (80-150Nm).
LED Indication & Calibration
LED indication:
1) Green LED indicates 24 V DC supply; it blinks during operation. If "run-in" is not used, this function
must be deactivated in the tool.
2) Yellow LED indicates control.
The blink sequence indicates if the valve is closing or opening.
3) Red LED indicates high or low level alarm, depending upon the setup.
LED signal
ON/OFF/Frequency
Green
ON
Flash
OFF
Yellow
ON
OFF
Red
ON
Flash
OFF
Yellow +
Flash
Red
Instruktionsmanual - HBLC – Sensor & regulator (012-UK)
WE INCREASE
UPTIME
AND
EFFICIENCY
IN THE REFRIGERATION INDUSTRY
Functionality
Supply voltage connected
Run In start signal / in operation.
No supply voltage
Activation of valve control / and during calibration
Valve control not active
Alarm, high or low level, depending upon the setup.
Does not detect and sensor probe
No alarm
Power supply not sufficient
Apply liquid gasket / Teflon to the conical thread.
Mount the electronic part again and secure with two set
screws.
9 / 12
Advertisement
Table of Contents
