Zooming - Sharp Viewcam VL-Z1U Operation Manual

Basic Operations
Camera Recording
To pause recording
Press the Start/Stop button again. Record-
ing pauses, and the camcorder enters
Recording Standby mode.
To turn the power off
Set the Power switch to OFF without
pressing the Lock button.
Note:
• If the camcorder remains in Recording
Standby mode for more than 5 minutes, the
power will automatically turn off to save
battery power and to protect the tape from
being damaged. To resume recording, set
the Power switch to OFF and then back to v.
(The camcorder will make a confirmation
sound when it is left in Recording Standby
mode for about 4 minutes.)
20

Zooming

Zooming allows you to move visually closer
to or farther from a subject without physi-
cally changing your position.
When using the optical zoom, you can
enlarge the subject up to 10K.
P A U S E
Zooming in
Push the Power Zoom control to the T
(telephoto) side to get a close-up view (1).
Zooming out
Push the Power Zoom control to the W (wide
angle) side to get a wide field of view (2).
W
Zoom range indicator
• The zoom range indicator shows you the
current zoom setting.
• The zoom speed depends on how far you
push the Power Zoom control.
Notes:
• The camcorder is unable to focus when
zooming in on subjects within 5 feet (1.5 m).
• See page 29 for how to use the digital zoom.
Zooming in (when you want to center
attention on the subject)
Zooming out (when you want to include
the surroundings)
T Z OOM 3
Power Zoom
control