Sharp AR-C250 Operation Manual page 150

Misfeed in the exit area of the copier
When misfed paper is lodged in the fusing roller of the copier and can
not be pulled out, open the front cover of the copier and turn the roller
rotating knob in the direction of arrow to remove the misfed paper.
Push the finisher toward the copier and latch it in place.
3
Confirm that the misfeed display is cleared.
If the message indicating a misfeed is still displayed, check the
inside of the copier and remove any remaining misfed paper.
CAUTION
Use caution while latching the finisher into place.
To prevent pinching your fingers, do not place your hand or fingers
on the release lever while moving the finisher toward the copier.
FINISHER (AR-FN4)
7-27