XBody TRAINING SUIT User Manual page 16

After the wires are prepared the electrodes can be installed. Each electrode must be put in a
containment (electrode cover) before installation. The geometry of the electrodes defines the areas
of their installation:
Eight "Square" formed electrodes are required. One for each of the four installation points in
the pants, one for each side of the belt (yellow) and two for the middle of the vest (green).
Four "D" formed electrodes are required. Two for the sides of the vest (orange) and two in
the back of the vest (white).
Four "L" formed electrodes are required. Each is for the top of the vest (red and blue).
Note: If a client reports lack of stimulation sensation to the trainer for any area of the body it usually
indicates a disconnected electrode. If such happens stop the stimulation, reconnect the electrode
(check other connections if necessary) and resume the training.
Step 13: Install the "D" formed and the "Square" formed electrodes. Connect the snap fastener of each
attachment point
wire with the of the electrode on the Velcro strap side of the containment.
User Manual
Version: 1.1
Page: 16 / 29