Toshiba Satellite U840 Maintenance Manual page 167

Chapter 4 Replacement Procedures
Figure 4-11-3 Disconnect LCD cable from connector on back of LCD
Installing the LCD Unit
The following describes the procedure for installing the LCD Unit.
1. Connect the LCD cable to the connector on the back of LCD; Stick the MYLAR tape
on the connector of LCD cable.
2. Place the LCD Unit on the display cover.
3. Secure the LCD Unit with the following screws, and connect LCD cable with CCD
FPC.
• M2.0×2.5
4. Secure the display mask with following screws
• M2.0×2.5
5. Cover screws with Screw MYLAR cover x4PCS
NOTE: When installing the display mask, make sure there is no gap between the display
mask and the display cover.
Satellite U840 Maintenance Manual (960-Q08)
screw x4PCS
screw x4PCS
40