DeLonghi ECAM65*.55 series Instructions For Use Manual page 27

DISPLAYED MESSAGE
GROUND TOO FINE. ADJUST
MILL
ESC
SELECT A MILDER TASTE OR
REDUCE COFFEE AMOUNT
ESC
INSERT WATER SPOUT
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
PUSH
POSSIBLE CAUSE
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted or is
inserted incorrectly
The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
The infuser (A19) has not been replaced after
cleaning.
REMEDY
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 11) one click clock-
wise towards 7 while the coffee mill is in
operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section "9.5 Adjusting the coffee mill"). If the
problem persists, make sure the water tank
(A16) is fully inserted.
Insert the hot water/steam spout (C6) in the
appliance and deliver a little water until the
flow becomes regular.
Select a milder taste by pressing "AROMA" (B5)
or reduce the quantity of ground coffee (maxi-
mum 1 measure).
Insert the water spout as far as it will go.
18).
Insert the infuser as described in section "15.9
Cleaning the infuser".
26