Ion Technologies SHR series Operation Manual

Ion Technologies SHR-HR
Submersible Sewage Pump
Single Seal, Single Phase, & Three Phase Power

Safety Warnings

Thank you for purchasing your Ion Technologies
Pump. To help ensure years of trouble-free operation,
please read the following manual carefully.
CAUTION: Read these safety warnings first
before installing, servicing, or operating any
pump.
This manual contains important information for the
safe use of this product. Read this manual completely
and follow the instructions carefully. Reasonable care
and safe methods relating to the installation and
operation of this product should be practiced. Check
local codes and requirements before installation.
WARNING: Risk of electrical shock or
electrocution. May result in serious injury or
death or fire hazard. Installer must disconnect all
electrical sources prior to installation, handling or
servicing. Only qualified personnel may install this
system. NFPA 70/National Electric Code (NEC) or
local codes must be followed. System must be
properly grounded according to NEC. Do not lift pump
by power cord.
WARNING: Biohazard risk. Once waste
water source has been connected to system,
biohazard risk exists. Installer(s) and/or service
personnel must use proper personal protective
www.ionproducts.net
OPERATION MANUAL
Dated: 11/27/2017
Document Name: SHR-HR_OM.indd
equipment and follow handling procedures per OSHA
29 CFR 1910.1030 when handling equipment after
waste water source has been connected to system.
WARNING: Risk of Asphyxiation. Installer(s)
and/or service personnel must use proper
personal protective equipment and follow OSHA 29
CFR 1910.146 or OSHA 29 CFR 1926. Pump may be
installed in a location classified by as a confined
space.
WARNING: Risk of fire or explosion. Do not
smoke or use open flames in or around this
system. This system is not intended for use in
hazardous locations per NFPA 70 National Electric
Code. Do not pump flammable liquids. Consult factory
for optional equipment rated for hazardous location
use.
WARNING: Cutting risk. Risk of serious
cutting or amputation exists. Disconnect all
power sources prior to servicing pump. Pump may
start without warning.
CAUTION: Do not modify the cord and plug.
When using the cord plug into a grounded
outlet only. When wiring to a system control, connect
the pump ground lead to the system ground.
CAUTION: Do not run the pump dry. Dry
running can overheat the pump (causing
burns to anyone handling it) and will void the warranty.
The pump normally runs hot. To avoid burns, allow it
to cool for 30 minutes after shut down before handling
it.
Submersible sump pumps are not approved for use
in swimming pools, recreational water installations,
decorative fountains or any installation where human
contact with the pumped fluid is common.
Do not throw away or lose this manual. Keep it in a
safe place so that you may refer to it often for the
continued safe operation of the product.

Overview

The MSP-SHR & MSP-HR Series are solids handling
pumps that can be used to pump RAW SEWAGE
for COMMERCIAL and DOMESTIC use, but are not
intended to handle large rags, mop heads or strings.
Page 1 of 8