Matco Tools MFJ2QL Operating Manual

Model # MFJ2QL
Description
Model MFJ2QL service jack is a self-contained device designed for lifting, but not sustaining, a partial vehicular
load. It consists of a frame with wheels and swivel casters supporting a mechanism that actuates a pivoting lift
arm equipped with a saddle. It is designed for use by professional auto mechanics.
Before Use
Air may become trapped in the hydraulic system during transit. To purge air:
1. Open release valve by turning handle counterclockwise.
2. Pump handle rapidly 4 full strokes. This will expel air that may have entered oil passages during transit.
3. Close release valve by rotating handle clockwise and pump handle.
4. If lift arm raised, jack is ready for use. If not, repeat
this procedure.
Inspection
Visual inspection should be made before each use
of the jack, checking for leaking hydraulic fluid and
damaged, loose or missing parts. Each jack must be
inspected by a manufacturer's repair facility immediate-
ly, if subjected to an abnormal load or shock. Any jack
which appears to be damaged in any way, is found to be
badly worn, or operates abnormally MUST BE
REMOVED FROM SERVICE until necessary repairs
are made by a manufacturer's authorized repair facility.
It is recommended that an annual inspection of the jack
be made by a manufacturer's authorized repair facility
and that any defective parts, decals or warning labels
be replaced with manufacturer's specified parts.
A list of authorized repair facilities is available from the
manufacturer.
FOR YOUR SAFETY AND TO PREVENT INJURY:
2 Ton Capacity Heavy Duty Quick To Load Service Jack
Use Service Jack for
lifting purposes
ONLY.
Model 1003
3 TON
CAPACITY
RATCHETING
JACK STAND
Always support
vehicle with
jack stands.
THIS IS A LIFTING DEVICE ONLY. DO NOT MOVE OR DOLLY
THE VEHICLE WHILE ON THE JACK. IMMEDIATELY AFTER
LIFTING SUPPORT THE VEHICLE WITH APPROPRIATE
MEANS.
DO NOT OVERLOAD. OVERLOADING CAN CAUSE DAMAGE
TO OR FAILURE OF THE JACK.
LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE
VEHICLE MANUFACTURER.
CENTER LOAD ON SADDLE PRIOR TO LIFTING. OFF-CENTER
LOADS MAY CAUSE DAMAGE TO JACK, LOSS OF LOAD,
PROPERTY DAMAGE, PERSONAL OR FATAL INJURY.
THIS JACK IS DESIGNED FOR USE ONLY ON HARD LEVEL
SURFACES CAPABLE OF SUSTAINING THE LOAD. USE ON
OTHER THAN HARD LEVEL SURFACES CAN RESULT IN JACK
INSTABILITY AND POSSIBLE LOSS OF LOAD.
NO ALTERATIONS TO THE JACK SHALL BE MADE.
Model 1003
3 TON
CAPACITY
RATCHETING
JACK STAND
READ, STUDY AND UNDERSTAND THE OPERATING MANUAL
PACKED WITH THIS JACK BEFORE OPERATING.
FAILURE TO HEED THESE WARNINGS MAY RESULT IN LOSS
OF LOAD, DAMAGE TO JACK, AND/OR FAILURE RESULTING
IN PROPERTY DAMAGE, PERSONAL OR FATAL INJURY.
1
Rev. 10/11/01