Page 1
Instruction Manual DESCRIPTION The Aquasun 3CD is a premium automatic solar controller with temperature adjustment, manual, winter and tropical mode features. This unit is fitted with current detection on the auxiliary power socket; the solar pump can only operate if the current load on the controllers auxiliary socket is within a certain range (e.g.
Dontek PD01 grinding drill or a small pilot be sealed to prevent water ingress. hole can be drilled and a 14.0mm drill-bit used spinning in a counter clockwise direction...
Page 3
*Default is a AQUASUN 3CD INSTALLER SETTINGS RUN=>20 and trip >99. Once the Advanced settings have been PUMP LOAD SETTING adjusted all the above settings will be saved *** IMPORTANT *** The controller will not and the unit will restart.
AQUASUN 3CD INSTALLATION started (this will most likely occur at night INSTRUCTIONS and therefore requires the filtration to run at night) and will attempt to cool the pool to 1°C above the temperature limit. Normal heating...
Page 5
NOTES NOTES 1. If a sensor fault is detected the controller will display which sensor failed (POOL and/or ROOF) and the type of failure. 2. After a power outage all configurable items are retained & the clock (if used) will keep time for up to 14 days. 3.
Page 8
DEALER/INSTALLER NAME SERIAL NUMBER DATE INSTALLED For service assistance phone 1300 130 693 Dontek Electronics Pty Ltd www.dontek.com.au PO Box 239, Bayswater VIC 3153 Australia Phone: +613 9762 8800 Fax: +613 9762 8874 Email: sales@dontek.com.au Aquasun 3 CD Instruction rB2.docx...
Need help?
Do you have a question about the Aquasun 3CD and is the answer not in the manual?
Questions and answers