RHINO LOADER 4211 Operator's Manual page 59

Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use Cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
Before operation, a complete inspection and service is required to ensure the loader is in a good and safe
working condition. Damaged and/or broken parts should be repaired and/or replaced immediately. To ensure
the loader is ready for operation, conduct the following. OPS-L-0027
The operator's manual and safety signs affixed on
the unit contain important instructions on the safe
and proper use of the equipment. Maintain these
important safety features on the implement in good
condition to ensure the information is available to
the operator at all times.
• Ensure the manual canister is secured to the
equipment with the operator's manual inside.
• Ensure all safety signs are in place and legible.
Replace missing, damaged, and illegible
decals. OPS-U- 0011
MOUNT ASSEMBLY
• Inspect condition of mounting frame weldment.
• Ensure all bolts and screws are in position and
are properly torqued.
• Ensure all pins are in place and fastened with
screws.
• Ensure frame is properly mounted to tractor
and hardware is
tightened. OPS-L-0004_A
4211-4211SS 01/11
© 2011 Alamo Group Inc.
OPERATION
properly installed and
Operation Section 4-13
(SG-15)
Mount Frame Assembly