LaserLiner CompactPlane-Laser 3D Manual page 13

4
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out
levelling at great distances or when the laser
lines are no longer visible. To work with a laser
receiver, switch the line laser to hand-held
receiver mode by keeping button 5 (handheld
receiver mode on / off) pressed. The laser lines
will now pulsate with high frequency, making
the laser lines darker. The laser receiver can
detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Preparing the calibration check
It is possible for you to check the calibration of the laser. To do this, position
the device midway between 2 walls, which must be at least 5 metres apart.
Switch the device on (Laser cross ON). The best calibration results are
achieved if the device is mounted on a tripod.
1. Mark point A1 on the wall.
2. Turn the device through 180° and mark point A2. You now
have a horizontal reference between points A1 and A2.
1.
A1
2.
Performing the calibration check
3. Position the device as near as possible to the wall
at the height of point A1.
CompactPlane-Laser 3D
A2
13
EN