Attachments On Request; Battery Charger - Stiga Cruiser 430 Li 80 series Operator's Manual

Pedestrian-controlled walk-behind battery powered lawn mower
Hide thumbs Also See for Cruiser 430 Li 80 series:
Table of Contents

Advertisement

13. The cut grass is
not collected in the
grass catcher.
14. Mowing is difficult.
15. Excessive noise and/
or vibration is experien-
ced whilst working.
16. Battery power re-
serve is low.
17. The battery charger is not
recharging the battery.

15. ATTACHMENTS ON REQUEST

15.1
"MULCHING" KIT
It cuts the grass cuttings finely and leaves them on
the lawn, instead of collecting them in the grass
catcher (for compatible machines) (Fig.36.0).
15.2
BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig.37.0).
The list of approved batteries for this machine
is found in the "Technical Data" table.
15.3

BATTERY CHARGER

Device used to recharge the battery (Fig.38.0).
The cutting means has collided with a
foreign object and received a knock.
The inside of the chassis is dirty.
The cutting means is not
in good condition
Cutting means fittings are loose or
the cutting means is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
Immediately turn off the motor
and remove the safety key.
Inspect for damage and contact a Technical
service centre for the replacement of the
cutting means if necessary (par. 8.1).
Clean the inside of the chassis to
ease the grass discharge towards
the grass catcher (par. 7.3.2).
Contact a Technical service centre
for the sharpening or replacement
of the cutting means.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.1).
Optimise operations (par. 7.2.1).
Use a second battery or extended
battery (par. 15.2).
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
EN - 15

Advertisement

Table of Contents
loading

Table of Contents