Hvac Selection - Radio Thermostat CT101 Install Manual

HVAC Selection

• Set the HVAC TYPE switch in the NORM position if you have conventional
natural gas, propane, oil, or electric heat. If you have a HEAT PUMP system set
the HVAC TYPE switch to HP. They are located in the battery compatrment.
• Set the HEAT TYPE switch in the GAS position if you have normal gas or oil heat
or if you have a heat pump with gas or oil auxiliary heat. Put the HEAT SOURCE in
the ELEC position if you have normal electric heat or if you have a heat pump with
electric auxiliary heat.
Install 4 AA Batteries
• Install 4 AA alkaline batteries [required] following the
marked polarity in the battery compartments. Put the
battery in negative end first against the spring, then
push the positive end in.
IMPORTANT: Press the RESET button (under top
cover) to implement the HVAC switch selections.
• With all the wires connected it is time to turn the AC power back on. Do this at the breaker you used
to switch it off. The CT101 will power-up in the OFF mode. Your CT101 is not configured to operate
your HVAC system yet. You must now configure your thermostat for your HVAC system.
HEAT
PUMP
NORMAL GAS
HVAC
TYPE
HVAC
TYPE
AA
AA
AA
AA
8
PG
ELEC
HEAT
TYPE
HEAT
TYPE