Advertisement
Available languages
Available languages
1. Loop new bett around Carpet/Bare
Floor selector shaft and agitator
belt
groove. Make sure belt is routed in the
belt guide as shown. See illustration for
correct belt routing.
Carpet/Bare
Floor Selector
S
2.
Reinstall
agitator
back
into nozzle
by
placing
end caps into grooves.
End Cap
Groove
3. After
reinstalling
the agitator,
turn it
by hand to make
sure that belt is not
twisted
or pinched
and that all rotating
parts
turn freely.
4.
Place the vacuum
cleaner
in the
upright position
standing
on the handle.
This will minimize
wheel
interference
when installing
lower plate.
5.
Reinstall
lower
plate by (1) aligning
tabs on front edge of lower plate with
slots in the nozzle
and (2) rotating to
installed
position.
6.
Lay vacuum
cleaner
on the floor
with
the bottom
up and nozzle
flat.
7.
Install the four screws to the nozzle
covet
Four
8. Route nozzle hose to hose holder.
Align nozzle hose bracket with retaining
bracket on body and slide down unit it
clicks into place.
9.
Return the vacuum
cleaner to the
upright
position before
plugging
into an
electrical
outlet.
- 21 -
Advertisement
