Bad Or Poor Connection - iPazzPort KP-810-61 User Manual

(3) Please switch the power button to the position "on" ( a blue light will blinks several times and then go off)
(4) To check out if the system requirement of the keyboard is compatible with the PC
(5) Please make sure the keyboard is not locked.(the working indicator will answer every gesture but no result on the monitor )
just press the keys "Fn" and ";" ( with a lock icon on it ) to unlock it
Attention :
Please refer to page 4(RF connection) to establish connection between the keyboard and the USB receiver if the tough
disconnection still stands (Your PC has recognized the USB receiver but still no response on the screen
after you power on the keyboard and slide on the touchpad, which means the USB doesn't pair with the keyboard in advance.) .

2).Bad or poor connection:

This may result from these reasons below that you should check out:
(1) Please make sure the resource signal is strong enough and both the devices are in good condition.
(2) Frequency interference always exists ,but we could still do something is to reduce it to the bottom by shutting off some other
unnecessary units around ,or putting the keyboard closer to the PC orTV box.
(3) Make sure your keyboard are not in low power capacity status .
(4) Signal strength may result from some stuffs between the keyboard and PC,so just put away the suspected stuffs between each
other.
(5) To make sure the keyboard is compatible with the PC by referring to the system requirement of the keyboard
(6) The signal may be interrupted by uncertain reasons ,you may pull out the USB receiver or turn off the keyboard to restart the
basic connection from beginning.
(7) The keyboard have an automatic sleep and wake mode to prolong the standby time, you may click any key to wake it up before
you slide or click on the touchpad.
3) Still have problem? Please contact us on social platform iPazzPortfans, or email us at support@ipazzport.com
7