Assembly - Craftsman C459-52831 Operator's Manual

Figure 1
Figure 2
Figure 3

ASSEMBLY

NOTE: All references to left or right side of the snow thrower is
from the operating position only.
Positioning the Upper Handle
1. Remove packing material, if present.
2. Raise the upper handle in the direction shown in Figure 1 until it
clicks into the operating position. Make sure not to pinch or crimp
the cable.
3. Tighten the knobs. See Figure 2.
Chute Assembly
The pitch of the chute assembly controls the angle at which the snow
is thrown. Adjust the chute assembly by following the instructions
below.
1. Loosen the wing knob found on the left side of the chute assembly
and pivot the upper chute upward or downward to the desired pitch.
Retighten the wing knob before operating the snow thrower.
2. Position the chute assembly opening by using the chute control
handle to throw the snow in the desired direction. See Figure 3.
IMPORTANT: Do not use the chute control handle to lift the snow
thrower
8