Usb Operation; Repeat-Random - Roadstar RCR-4625U User Manual

3 English
CD-MP3 OPERATION
1. Set the function selector (12) to "CD" mode.
2. Open the CD door (16) and place a CD-MP3 disc with the label up in the CD
compartment.
3. Close the CD door (16). Focus search is performed and playback will start auto-
matically from the first track.
4. Adjust the volume control (13) to the desired level.
PROGRAMMING
Up to 20 tracks can be programmed for disc play in any order.
1. Stop the playback by pressing STOP (5).
2. Press PROGRAM (8), the display (1) will show "P01" and flash.
3. Select desired track by using BACK (6) or NEXT (7) buttons.
4. Press PROGRAM (8) again to confirm desired track into the program
memory.
5. Repeat step 3 and 4 to enter additional tracks into the program memory.
6. When all the desired tracks have been programmed, press PLAY (4) to play the
disc in the order you have programmed.
7. Press STOP (5) twice to terminate programmed play.

USB OPERATION

1. Set the function selector (12) to "CD/USB" mode.
2. Plug an USB device into the USB socket (17).
3. Press & Hold MODE (4) to select USB mode.
4. Playback will start automatically from the first track.
5. Adjust the volume control (13) to the desired level.
PROGRAMMING
The PROGRAMMING operation is the same as that of CD-MP3.
Note: Some mp3 player may not be able to play via the usb socket. this is not a
maul-function of the system.
Note: To avoid damage to USB memory, remove it only when the radio is turned
off.
REPEAT - RANDOM
Press repeatedly
(only for CD and USB mode).
AUX IN OPERATION
1. Use one male to male 3.5mm jack cable (not included) to connect any external
audio device to the AUX-IN socket (21).
2. Music control (play, pause, etc) must be done from your external device.
3. Adjust the volume control (13) to the desired level (You may also adjust the vol-
ume level on the external device).
Note: Disconnect jack plug from the radio when you no longer want to use this

REPEAT-RANDOM

button (8) to select the desired playback mode