Pentair Pool Products IntelliChlor PC100 Installation And User Manual page 9

Preparing the SiteMount the Power Center enclosure
1. Remove the screw securing the Power Center cover and remove the cover.
2. Mount the Power Center on a flat surface such as a wall or post and mark each
mounting bracket screw hole location. There are two (2) screw holes and a keyslot
for the top and lower bracket.
3. Drill six ¼ inch (6.35 mm) holes. Install anchors if necessary and one screw for
each bracket keyslot location.
4. Position each Power Center keyslot (top and lower) slot over the two mounting
screws just installed. Tighten the two screws to secure the enclosure.
5. Install and tighten four mounting screws (two in the top and two in the lower
bracket).
Bracket screw hole
Cover screw hole
Bracket screw hole
Bracket keyslot
Bracket screw hole
Bracket screw hole
Bracket keyslot
IntelliChlor Power Center Installation Guide
4