Advertisement
The active fuel-air system compares the measured amount of incoming air with the necessary
amount of air to provide quality combustion process in the respective mode and brings it in
conformity by means of control of the speed of the smoke fan.
This ensures quality combustion process completely independent on the parameters of the
chimney – length, height, resistance, pass-through capacity, clogging, draft, or on the parameters
of the pipework, providing the necessary air. In extreme situations – inadmissible or complete
clogging, the stove will be shut down after warning message.
The ash remaining from the fuel combustion is collected in an ash box.
The flue gases are forcedly discharged into the chimney by means of an integrated smoke fan,
controlled in accordance with the settings and mode of operation selected.
There is a protection system against a clogged or destroyed chimney, which would stop the stove
operation.
The whole operation of the stove is controlled in an intelligent manner by the integrated electronic
unit – a dedicated controller. It has two necessary operation control sets - factory and user
settings, programmed in it.
The stove can also be controlled by the infrared (IR) remote device provided.
Aiming at preservation of health, life and property of the user, there are safety functions provided,
which will stop the stove operation in cases of incorrect and (foreseeable) dangerous modes of
operation.
Caution:
Usage and handling of this appliance require certain minimum of knowledge and skills
acquired.
All instructions provided by the manufacturer must constitute an important and essential
part of these knowledge and skills, be always available to the user and abided by in order
to minimise or completely exclude all possible risks and dangerous consequences.
This appliance must not be used by children less than 12 years old and individuals with reduced
physical, sensory or mental capacities, or with insufficient experience and knowledge, unless
supervised or instructed concerning the safe use of the appliance (by the person in charge for
their safety) and are fully aware of the hazards.
Children must not be allowed to play with the appliance.
No cleaning and servicing of the appliance may be done by children without supervision.
Always make sure that the stove is in a safe status, whether in operation or during its downtime.
The stove can be operated only with its firebox door closed.
Do not allow opening of the stove door during operation and in presence of fire for more than 15
seconds. This can be extremely dangerous.
During stove operation, some surfaces are heated to high temperatures, which if touched
accidentally or erroneously, severe heat-related injuries can occur.
Modifications of the appliance are not allowed.
When some part needs replacement, only original parts must be used.
In cases of damaged power supply cable, it must be replaced by the manufacturer or one of its
service agents, or another person of similar qualification, in order to avoid any hazard.
This stove is manufactured in conformity and correspondence with the following European
standards: BDS EN 14785, BDS EN 60335-1, BDS EN55014-2, BDS EN 55014-2, BDS EN
61000-3-2 and BDS EN 61000-3-3.
All local, national and European standards must be observed during installation and
operation of the appliance.
The manufacturer shall bear no direct or indirect, civil or penal liability in cases of:
Failure to comply with the instructions.
Failure to comply with usual rules for safety.
GENERAL SAFETY
STANDARDS AND LEGISLATION
LIABILITY
17
Advertisement
