2-23. MECHANISM DECK
(MT-DCMM1-163)
2 Two screws (S13)
(damper)
3 Two screws (S13)
(damper)
OK
Note : When installing damper (MD),
put it together in the figure.
2-24. CLV BOARD
2 Motor flexible board
(CN5801)
4 Two screws (S14)
(M1.4)
5 CLV board
3 Remove the solders of the spindle
motor flexible board.
4 Damper (MD)
NG
NG
1 Flexible board
(CN5902)
5 Two dampers (MD)
A
7 Claw
1 Rotate the worm gear in the direction
of the arrow A and move the torsion
spring (limitter) in the direction of the arrow B.
B
Torsion spring (limitter)
S13
S14
2-10
6 Damper (MD)
9 Hold the part maked A in the
figure trying not to touch either
over write head or OP.
Pulling the mechanism deck
(MT-DCMM1-163) toward you,
pull out it to the disc slot side.
8 Claw
Worm gear
A
4
1.6