Operation - Magnavox MD6949 Owner's Manual

RADIO:
1. Slide the Function Selector to AM or FM position to turn on the radio and set to desired band.
The POWER Indicator will illuminate.
2. Turn the TUNING Knob to receive the desired radio station.
3. Turn the VOLUME Control Knob to adjust volume level as desire.
4. When finished listening, slide the FUNCTION Selector to OFF position to shut off the unit.
The POWER Indicator will turn off.
Antenna:
This unit has a built-in AM/FM antenna, which provides adequate reception in most areas. If reception
is weak, turn the unit to improve reception.
CD:
1. Slide the Function Selector to CD/BT/AUX IN position to turn on the CD.
The POWER Indicator will illuminate.
The LED Display will illuminate and indicate "--" then " no" will appear.
2. Open the CD Door then place a CD disc on the center spindle, with the printed side faced up.
3. Close the CD door. Wait a few seconds; the number of the total tracks will appear on the LED Display.
4. Press the /BT (Play/Pause/BT) Button to start playback the first track on the disc. The
PLAY/PAUSE Indicator will illuminate.
5. During playback:
Turn the VOLUME Control Knob to adjust volume level as desired.
Press the /BT
blinking. Press the button again to resume normal playback, the PLAY/PAUSE Indicator will
stop blinking.
Press the or Buttons repeatedly to skip the tracks.
Press and hold the
play.
6. To stop CD playback, press the
7. When finished listening, slide the Function Selector to OFF position to shut off the unit. The
POWER Indicator will turn off.
Programmed Playback:
Up to 20 tracks can be programmed playback as follows:
1. In CD stop playback mode, press the PROG (Program) Button. "01" will appear on the display
and blink. The PROG (Program) Indicator will illuminate and blink too.
2. Select the first specific track to be programmed by pressing the
3. Press the PROG (Program) Button to store the selected track into the memory.
4. Repeat steps 2 and 3 until all the specific tracks stored into the memory.
5. Press the /BT (Play/Pause/BT) Button to start program playback. The PROG (Program)
Indicator will stop blinking.
6 To stop program playback, press the
again to resume program playback.
7. To erase the program, press the
will turn off.

OPERATION

(Play/Pause/BT) Button to pause, the PLAY/PAUSE Indicator will start
or Buttons to fast search the specific section then release the button to
(Stop) Button. The total number of tracks will appear on the display.
(Stop) Button. Press the
(Stop) Button again in stop mode. The PROG (Program) Indicator
7
or Buttons repeatedly.
/BT (Play/Pause/BT) Button