Hollow Shaft With Splines - Siemens BA 2030 SERIES Operating Instructions Manual

4.9.5

Hollow shaft with splines

*
①
②
③
④
⑤
⑥
⑦
Figure 4-9
Instead of the nut and threaded spindle shown in the diagram, other types of equipment such
as hydraulic lifting equipment may be used.
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft ends and
flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Please contact
Technical Support if you notice any damage.
3. Apply the mounting paste
4. Fit the gearbox using the disk
the hollow shaft
5. Replace the nut
specified torque.
You have mounted the hollow shaft with splined shaft.
Table 4- 11
Thread size
Tightening torque [Nm]
BA 2030
Operating Instructions, 11/2017, A5E37880173A/RS-AE
Not included in scope of supply
Machine shaft
Hollow shaft
Hexagon nut
Threaded spindle
Disk
Locking ring
Mounting paste
Mounting the hollow shaft with splines
⑦
②
.
③
and the threaded spindle
Tightening torque for the screw
M5
5
4.9 Installing and removing the shaft-mounted gearbox
①
to the machine shaft
⑤ ④
, threaded spindle
④
with a screw. Tighten the bolts to the
M6 M8 M10
8 8 14
. Apply the paste uniformly.
③
and nut . Support is provided by
M12 M16 M20 M24
24 60 120 200
Installation
M30
400
47