Table of Contents
Advertisement
HYDRA-X10 S
ETUP
The setup for the HYDRA-X10 Body module requires up to three simple connections.
1. Connect the VIN power source via barrel connector J7. When VIN power is present, the LED D3 will
light up. If VIN voltage is larger than 16V, the PAC5210's Multi Mode Power Manager will be engaged
and the VSYS (5V) regulator will be enabled. This event will result in LED D2 lighting up.
2. Connect the USB Serial Communications to J8: ensure the board's USB cable is connected to a PC
computer. LED D1 will light up when the connection is made.
3. Connect the USB SWD to J9. Ensure the board's USB cable is connected to a PC computer. Coocox
IDE will signal connection status.
Figure 7:HYDRA-X10 Connections
-
11
-
Rev 1.0 June 2014
Advertisement
Table of Contents
