Ro Membrane Element Notes; Component Descriptions - Sea Recovery Aqua Whisper DX 450-1 Owner's Manual

3.8

RO MEMBRANE ELEMENT NOTES

CAUTION: Some systems are
shipped WITHOUT the Reverse
Osmosis Membrane Element. This is to
accommodate Boat Builders that will
install the System well in advance of
commissioning the boat and the System.
DOES THIS SYSTEM HAVE R.O. MEMBRANE(S) INSTALLED
OR NOT?
If not, is it your intention to install the R.O. membrane(s)
at this time, or do you wish to install them at a later date
when the boat is commissioned?
If the R.O. membrane element has been installed, there
will be a R.O. Membrane Element Serial Number tag,
illustrated below, attached to the High Pressure Vessel(s).
Find this Serial Number tag to ensure that the R.O.
membrane element(s) has been installed.
Sea Recovery
Rancho Dominguez, California 90220 U.S.A.
Tel: 1-310-637-3400 | Fax: 1-310-637-3430
Email: srcsales@searecovery.com
087945021505
SERIAL NO:
FLOW: BRINE INLET END
DATE:
October 15, 2005
If the R.O. membrane element Serial Number tag is
missing or does not contain a serial number and date
then the R.O. membranes are not installed. If the R.O.
membrane elements are not installed and you wish
to install them at this time contact Sea Recovery and
supply us with your original Purchase Order Number,
Sea Recovery's Invoice Number, and this System's
Serial Number.
WARNING: If the Reverse Osmosis
Membrane Element is not to be installed
at this time, ensure that you leave a
visible note at the system controller and
at the front of the control panel informing
the end user that:
The Reverse Osmosis Membranes
Elements are not installed; to contact the
factory for the R.O. Membrane Elements;
and DO NOT operate the system without
the R.O. Membrane Elements installed.
** Extensive damage will occur if
the system is operated without the
R.O. Membrane Elements installed. **
Aqua Whisper DX Modular 450-1800
Damage to the system caused by the
operation of the system without R.O.
Membrane Elements installed:
• Is NOT covered by the Sea Recovery
warranty
• Is the liability of the installer if the
installer did not notify the end user.
• Is the liability of the end user if the
installer notified the end user that the
R.O. Membranes were not installed and
to not operate the system without the
R.O. Membrane elements installed.
Note: Symbol Used in this Section.
** Indicates items supplied by owner/installer
*** Indicates optional equipment.
3.9

COMPONENT DESCRIPTIONS

All components supplied by Sea Recovery, both standard
and optional, are described in this section along with
items required or desired by the installer. The location,
operation, and purpose of each major component are
briefly explained in this section.
Use of third party, Non Sea Recovery, components
will lead to premature failure, added operating and
maintenance costs, and increased labor. Using 3rd party,
Non Sea Recovery, components will void any and all
Sea Recovery Warranty. We only wish to help you enjoy
the luxury of owning a Sea Recovery R.O. System. Treat
it properly by using only Sea Recovery supplied parts,
consumable, and accessories.
PREFILTRATION SECTION:
The Prefiltration Section filters and delivers the feed
water into the system. The raw feed water is filtered
to remove suspended solids larger than 5 Micron size
(5/1,000,000 of a meter). The prefiltration protects
the High Pressure Pump from premature wear and
the Reverse Osmosis Membrane Element from
premature fouling.
1. Inlet Thru Hull Fitting with Forward Facing Scoop
** is the point at which the feed water enters the
system. It is important that the installer utilizes a
forward facing scoop so that the system receives a
positive flow of water as the boat is under way.
Page 3-19