PJDX5900 SYSTEM User Instructions
Programmable Options
The PJDX5‐900 features several programmable options and pairing functions, to
allow an installer to customize this product to suit special vehicles. The
paragraph below details the general procedure for changing/using the options.
Read the summary table and option descriptions for further details on each
option.
Option Selection Procedure
1. Disarm the PJDX5‐900 using a valid Remote Control.
2. Hold both buttons of the Remote Control until it's green and red LED's
flash.
3. Press the top button once for each count in the option that is to be
selected (three presses for option #3 etc).
4. Press the bottom button to confirm you wish to select/change the option.
5. The Siren will respond by chirping once or three times to report the new
setting
Option Selection Summary Table
Option
Option Description
Number
3
Retrieve trigger diagnostics
5
Demo mode
7
Program new Remote Control
9
Shock sensor function
11
Millivolt sensor function
13
Shock sensor sensitivity
Option 3 – Retrieving trigger diagnostics
Each time the Siren is triggered, the source of the trigger is saved in the system
memory. The diagnostic information is retrieved by selecting option #3 (see
options selection procedure). The Siren will chirp and the Blue LED will flash the
number corresponding to the trigger source. The table below outlines the
numbers and types of trigger sources:
Trigger Number
1
Strictly Confidential
For use by Dynamco RV Beta Customers only
Copyright © Dynamco Pty Ltd all rights reserved
Millivolt Sensor
One chirp
response
See diagnostics summary
Disabled
See remote programming section
Disabled
Disabled
See sensitivity summary
Trigger Source Type
Three chirp
response
Enabled
Enabled
Enabled
Page # 7 of 11