Wireless Bridge Operation - Pinchi Security PJDX5-900 Instructions For Use Manual

PJDX5­900 SYSTEM ­ User Instructions
PJ9DX5‐900 alarm system. If the alarm is armed and active, the siren will sound.
While the alarm is disarmed, all Toolguard signals are ignored.
Wireless Bridge Operation (PJ9WB‐900)
The Wireless Bridge as a device that connects to negative trigger signal wire
from a standard (non‐radio) sensor. When a negative signal is detected, a trigger
message is transmitted to the PJ9DX5‐900 alarm system via RF.
Toolguard Operation (PJ9Toolbox‐Sen433)
The Toolguard Sensor is a passive sensor which monitors it's angle with respect
to gravity. If the angle of the sensor is changed, a radio signal is sent to the X3‐
433 alarm system. If the alarm is armed and active, the siren will sound. While
the alarm is disarmed, all Toolguard signals are ignored.
Strictly Confidential
For use by Dynamco RV Beta Customers only
Copyright © Dynamco Pty Ltd all rights reserved
Page # 11 of 11