Step 2 - For Toolguard Sensors; Step 2 - For Passive Infra-Red (Pir) Sensors; Sensor Operations; Latch Sensor Operation - Pinchi Security PJDX5-900 Instructions For Use Manual

PJDX5­900 SYSTEM ­ User Instructions
Step 2 – for Toolguard Sensors
Open new Toolguard Sensor as per the instructions provided with the sensor.
Momentarily press the sensor's learn button until the green LED in the sensor
flashes. The flashing green LED confirms a successful device pairing.
Step 2 – for Passive Infra‐red (PIR) Sensors
PIRs will enter "pairing mode" automatically for 10‐20 seconds each time the
sensor is powered up (i.e. battery re‐insertion). In "pairing mode", the green LED
will flash for 2 seconds, then remain off for 2 seconds, and cycle this pattern until
it is paired with a Siren or it's pairing time expires.
Sensor Operations
Latch Sensor Operation (PJ9LS‐900)
The wireless Latch Sensor is a passive device that remains inactive until the
internal magnet reed switch is activated. Where upon it transmits a trigger signal
to the Alarm. If the arming settling time has elapsed (30 seconds), the siren will
sound. Refer to the Latch Sensor installation instruction for details on correct
sensor placement.
PIR Operation (P9JPIR‐900)
The PIR Sensor is an active sensor that detects the movement of warm bodies as
they pass through a region in front of the sensor's "eye". The PIR accepts
arm/disarm commands from the Alarm. After arming, the PIR will wait 1 minute
before it becomes active.
The PIR sensor includes a red and green status LED, which reports the sensor's
current operating mode as follows:
• While disarmed the red LED will flash once every two seconds.
• Once the sensor is fully active, it's green LED once. When the sensor
triggers it becomes active it will flash the green LED once.
• The PIR will flash the green LED when it becomes disarmed and will flash
red then green when triggered.
Toolguard Operation (PJ9Toolbox‐Sen900)
The Toolguard Sensor is a passive sensor which monitors it's angle with respect
to gravity. If the angle of the sensor is changed, a radio signal is sent to the
Strictly Confidential
For use by Dynamco RV Beta Customers only
Copyright © Dynamco Pty Ltd all rights reserved
Page # 10 of 11