PJDX5900 SYSTEM User Instructions
Remote Operation (PJ9TX90M‐900)
• Momentarily pressing the top button will alternately arm and disarm the
Alarm.
• Holding the bottom button for 2 seconds will put the Alarm into panic
mode. During panic mode, the siren will "squawk" for 30 seconds, or until
the top button is pressed.
• A green and a red LED are located
under the top button.
• When a command is successfully
transmitted to the Siren, the green LED
will flash twice rapidly.
• When the Siren does not receive the
transmission, the red LED will flash several times.
Battery Replacement
Use a flat head screwdriver to carefully separate the
two body pieces taking care not to disturb the circuit
board. Remove the old batteries whilst paying
attention to the orientation of the positive and
negative terminals. Insert new batteries in identical
fashion to the original and re‐assemble remote. Test
remote control by pressing main button. For further
information, please contact your local Cyclops service centre. Remote battery
type is CR2016.
Siren Operation
Upon arming the Alarm, all sensors are ignored for the first 30 seconds. Once
triggered, the Siren will sound for 30 seconds, then reset for 5 seconds (remains
silent). Each paired sensor can trigger the Alarm a maximum of three times
during each Arm/Disarm cycle. The battery backup feature has been disabled for
FCC testing.
Strictly Confidential
For use by Dynamco RV Beta Customers only
Copyright © Dynamco Pty Ltd all rights reserved
Top button
Page # 6 of 11