Apache Manitou MX User Manual page 4

GENERAL INFORMATION FOR USE OF eBIKE
IMPORTANT
Before every ride check the brakes functionality and battery charge status.
During the ride on eBike always use cycling helmet!
Riding an eBike
Riding eBike is just like on any other bike. Just push and set off from the ground and pedal. The motor activates
itself after the crank spinning and operates further according to mode of assistance setted up.
In case of using the brakes the motor switches off automatically. This does not apply to the models with hydraulic
disc brakes whose levers are not equipped by all appropriate sensors. The motor by such models switches off
within two seconds after you stop pedalling.
As soon as you reach speed of 25 km/h the motor automatically switches off and reactivates when the speed
drops again below this limit.
The motor does not operate when you do not pedal or turn the cranks backwards.
Long-lasting ride with low rotation speed and high assistance mode can cause an overheating
and in case of high load motor damage even. At such case we strongly recommend to reduce
the assistance mode.
Regardless the selected gear it is suitable to stop pedalling shortly during the gear change.
That simplifies the gear change and reduces the wear of the motor.
Function of the eBike can be affected by external electromagnetic impacts
(e.g. radars, radio-locators, etc.).
RECOMMENDATION
After every ride connect the battery to the charger and let it charge. The battery doesn't have
memory effect therefore it's not required to discharge it completely before recharging.
RECOMMENDATION
In case of any problems with switching to lower or higher gear we
recommend additional installation of "Gear sensor'' that shortly
disconnects the motor during the gear change. The gearing does not
happen during full motor engagement which saves the motor itself
and all transmission components.
4