Sanyo GCD 1500 Instruction Manual page 3

1
COiiNECTIONS
.
L
. .
FM outdoor aerial
%
Simple indoor aerial
II
3-
Power supply
Connect the mains lead to an AC 230-240 V wall outlet.
Note:
AM loop aerial
P
Q
r
- Do not connect the mains lead to an AC outlet until all connections
have been made.
- Before connecting the mains lead, set the POWER switch to OFF.
II ,
Aerials
In areas close to a transmitter the simple indoor aerial is sufficient to
receive broadcasts. Extend the aerial wire as straight as possible and,
while listening to the sound from the system, secure it in a position which
yields minimal distortion and noise,
In fringe areas or where reception is distorted or noisy, an external aerial
(not supplied) should be connected instead of the simple indoor aerial.
Consult your dealer.
loop aerial
~ssemble the loop aerial as shown in figure.
Unwind the aarial wires (about 3 turns), then connect them to the AM
LOOP ANT. terminals. Place the loop aerial in a position which yields the
best AM reception, or attach it to a wall or other surface as shown in figure.
(not supplied)
Note:
- To minimize noise, the speaker, mains and any other leads should not
come close to the ~. ANT. socket.
- Do not place the unit beside a metal surface.
Speaker terminals
(SPEAKERS)
These terminals will accept speakers of 8 ohms minimum impedance.
The speaker wires should be connected to the speaker terminals with the
proper polarity. The red terminals are (+) positive and black terminals are
(-) negative.
Headphones socket
(PHONES)
Connect stereo headphones (8 ohms - 10 kohms, not supplied) for
monitoring orfor private listening. The speakers are automatically discon-
nected when headphones are connected to this socket.
-2-