Table of Contents
Advertisement
.
.",
LISTENING
TO THE RADIO
i
1. Press the TUNER
function
switch.
BAND
SELECT
Switch
2.
Select
the desired
band
(and FM mode)
using the BAND SELECT
FM MONO:
switch.
For receiving
weak (noisy) FM stereo broadcasts.
The reception
may
3. Tune in a desired
station by turning the TUNING
control.
be inproved,
but the sound will be monaural.
FM STEREO:
For receiving
FM stereo broadcasts.
The FM STEREO
indicator
will
light when an FM stereo broadcast
is received.
AM:
For receiving
AM broadcasts.
LISTENING
TO RECORDS
Note:
1.
-
Remove
the stylus protector.
2.
-
Be sure that the tone arm is detached
from the tone arm rest before
3.
operation,
and re-secured
again after use.
-
Do not turn the turntable
platter counter-clockwise.
4.
-
When operating
the unit for the first time, the tone arm might return to
its rest position.
This is not a malfunction.
5.
-
When operating
the unitforthefirst
time, the tone arm might not return
to its rest position.
Should this occur, shift the arm lift lever to up and
6.
,,ently move the tone arm to near the centre shaft of the turntable.
The
'tone
arm will automatically
return to its rest position,
This is not a
malfunction.
-
Never grasp or hold the tone arm and platter during operation
of the
7.
automatic
mechanism.
.
BEFORE RECORDING
AND DUBBING
Press the PHONO
function
switch.
Place a record on the platter (if required,
use the 45 rpm adaptor).
Select the speed with the speed selector depending
on the disc to be
played
(33 or 45 rpm).
Shift the arm lift lever backward.
The tone arm will ascends
from the tone arm
rest.
Slowly move the tone arm to the desired
position by hand. The platter
will begin to rotate.
Shift the arm lift lever forward. The tone arm will then descend
onto the
disc,
-
If you wish to momentarily
stop disc play, shift the arm lift lever
backward.
Shift it forward to start disc play again,
When play is finished,
the tone arm will return to its rest position and
the platter will cease rotation automatically.
'~
Recording
copyright
material
without
permission
of the copyright
owners is usually an infringement.
If you wish to re-record copy-
right material
permission from the copyright owner is necessary
SANYO does not approve of, and cannot be held responsible
for,
any unlawful use of this machine.
This unit features
ALC
(Automatic
Level
Control)
which
automatically
adjusts the recording
level.
Use TAPE B for recording.
*
'ress
the STOP/EJECT
button and load the cassette
for recording.
ewind the tape to the beginning.
3>Set
the DOLBY
NR switch to ON or OFF as desired.
During dubbing
operation,
the DOLBY
NR switch has no effect to the
copied tape.
Accidental
erasure
prevention
tabs
(for protecting
valuable
recordings)
Accidental
erasure
can be prevented
by breaking
out the tabs on the end
of the cassette
tape (where the tape is not exposed)
using
a
screwdriver
or similar implement.
If a tab is broken
out in error and you wish to re-record
the tape, simply
block the tab hole using adhesive
tape and the tape can be used for
recording
again.
A
r
"deA
'orcr02tape
I
J
Break out tab A for side A.
Break out tab B for side B.
-6-
Advertisement
Table of Contents
