Connecting Idc To Controls System - Invacare LiNX IDC User Manual

Invacare® LiNX IDC
Preparing IDC for transport in a vehicle
WARNING!
Risk of injury and damage due to loose parts
during transport
For transport IDC with LiNX must be completely
removed from power wheelchair and stored
safely.
– Disconnect and take off IDC for transport.
1. Disconnect bus cable.
2. Press and hold KLICKfix button A.
3. Take off IDC.
4. During transport of power wheelchair store IDC safely,
for example in glove compartment.

4.2 Connecting IDC to controls system

The IDC takes over control of the wheelchair and
may only be used by an attendant. It is imperative
that the wheelchair occupant himself is not allowed
to use the IDC.
Fitting should only be carried out by an Invacare
provider. When fitting, ensure that the bus cable
is routed and fixed correctly to avoid damage to
the bus cable.
10
1. Power down wheelchair controls.
2. Connect one end of bus cable to IDC, other end to free
bus socket on wheelchair.
In case there is no spare bus socket on controls
system, you can order a 4–way bus socket from
your Invacare provider.
3. The IDC is now connected to the controls.
For further information, see LiNX Service Manual.
1643411-A