Set Up The Machine ......................... 5; Free Arm Sewing: The Removable Extension Table; Accessories Storage Box; Change The Presserfoot - Kenmore 385. 12708 Owner's Manual

Set Up the Machine (Continued)
• Free-Arm Sewing: the Removable
Extension Table
• Accessory Storage Box
\
To Remove the Extension Table The lid of the accessory storage
(for free-arm sewing) box lifts open toward you.
1. Grip the table with your index finger Sewing accessories are conveni-
and thumb, as shown,
ently located in the box.
2. Pull gently to the left. The extension
table will snap out.
To Attach the Extension Table
(for flat*bed sewing)
1. Insert the tab and the pin into their
catches.
2. With your thumb and index finger,
gently snap in.
SECTION 2.
• Change the Presser Foot
Q
!
Use the correct presser foot for
the stitch you wish to sew.
To change the various presser
feet, raise the presser bar to its
highest position by lifting the
presser foot lever.
Loosen the presser foot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
PREPARE THE MACHINE FOR SEWING
Choose the Needle and Thread
• To Change the Needle
Flat
side
away
from
you
(
_",_"k Needle clamp screw
•-._ /
,_i
NOTE: Raise the needle bar to its highest
position by turning the hand wheel
toward you.
I, Loosen the needle clamp screw by
turning it toward you.
2, Remove the needle by pulling it down-
ward.
3. Insert the new needle into the needle
clamp with the flat side away from you.
4. Push the needle up as far as it will go.
5. Tighten the needle clamp screw firmly
with the rarge screwdriver from the
accessory box.