Setting And Using Fm Presets; Setting And Using The Alarms; Previewing Alarms And Turning Alarms On/Off - iHome Hello Kitty Si-B62 Instruction Manual

Setting and Using FM Presets

The unit allows you to store up to 10 FM radio station presets
1. Press and release the Power/Mode Button as needed until the FM indicator icon and current FM radio
frequency appear on the display.
2. Press the – or + Buttons to tune the radio to the desired station (hold to scan for the next clear station).
Clock/Presets Button to setting mode (P01- P10 will flash 3 seconds), push the –
3. Press and hold the
or + Buttons to select the preset number (P01- P10) you wish to set.
4. Press and release the Clock/Presets Button to confirm. Continue steps 2-4 until you have set up to 10
preset stations.
5. To listen to a preset FM station at any time, just push Clock/Preset Button on FM radio mode and cycle
to the desired preset.
9
P10
Si-B62
Using the

Setting and Using the Alarms

This unit has 2 separate alarms, each set the same way. Below we explain how to set Alarm 1.
/Alarm 1 Button.
To set alarm 2, follow the same steps using the
Alarms can only be set when unit is OFF.
Note: each step must be completed while display is flashing or step will time-out with any changes saved.
1. Press and hold the /Alarm 2 Button for 2 seconds until the hour display and AL1 alarm indicator flash.
2. Press the – or + Buttons to adjust the alarm time to the desired hour (hold for rapid setting).
Make sure you set the correct AM/PM alarm time. The PM indicator appears on the left of the display.
3. Press the /Alarm 2 Button to confirm the alarm hour setting. The minutes will flash.
4. Press the – or + Buttons to adjust the alarm minutes to the desired setting.
5. Press the /Alarm 2 Button to confirm the alarm time setting. The red indicator next to Buzzer will flash
6. Press the – or + Buttons to select the desired wake to alarm source: buzzer or FM radio.
7. Press the /Alarm 2 Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will
confirm clock setting is complete. The alarm indicator will remain on the display, showing the alarm is
armed.

Previewing Alarms and Turning Alarms On/Off

Quickly press and release an Alarm Button to view the current alarm time and wake source. Press again to
turn the alarm OFF, indicated by the red AL1 or AL2 alarm indicator disappearing from the display.
10
P11
Si-B62
Using the