See Figures 18 and 19.
UNPLUG YOUR ROUTER.
Failure to unplug your router could result in accidental
starting causing serious injury.
Remove screws (A) and handle cover (B l, See Figure
Note the location of the molded bend relief (C) on
the power handle cord. Also note all wiring in the
and how each
lead is connected
and wiring position must be
identical when installing new switch. See Figure 18.
Remove leads from switch (D) by inserting a 1/32 in.
nail or pin into switch lead receptacle
pulling on lead as sRown in figure 19. Remove nail or
pin with a twisting, pulling motion.
Make lead connections
to new switch. Push each lead
as far as possible into proper switch receptacle. Pull on
leads to check lead connections with lead receptacles.
Locate switch in handle and place leads so they won't
be pinched or contact screws when handle cover is
Make sure molded bend relief (C) is correctly positioned
in switch handle, then replace handle cover and screws.
Tighten all screws securely.