When servicing use only identical Craftsman replacement
pads. Use of any other parts may create a hazard or
cause product damage.
Only the parts shown on parts list, pages 23, 25 and 27 are
intended to be repaired or replaced bythe customer. All other
parts represent an important part of the double insulation
system and should be serviced only by a qualified Sears
Avoid using solvents
plastic parts. Most
plastics are susceptible
to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
Do not at any time let brake fluids, gasoline, petroleum.
oils, etc. come in contact
parts. They contain
damage, weaken, or destroy plastic.
When electric tools are used on fiberglass boats, sports cars,
it has been
found that they are subject to accelerated wear and possible
premature failure, as the fiberglass chips and grindings are
Consequently it is not recommended that this tool be used for
on any fiberglass
or plaster. During any use on these
materials, it is extremely important that the tool is cleaned
frequently by blowing with an air jet.
The use of any extension cord will cause some loss of power.
To keep the loss to a minimum and to prevent tool overheating,
use an extefision cord that is heavy enough to carry the
current the tool will draw.
A wire gage size (A.W.G.) of at least 14 is recommended for
an extension cord 100 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
Keep extension cords away from any routing area and
3osition the cord so that it will not get caught on lumber,
tools, etc., during routing operation.