Amber; Default Settings - Buffalo LinkStation 500 User Manual

Amber

After you change settings or format a drive, the power LED will blink amber. You can also confirm the current status
from Settings or NAS Navigator2.
Code
I12
I13
I14
I16
I18
I19
I20
I21
I22
I23
I25
I28
I46
I52
I54

Default Settings

Administrator's Name
Shared Folders
IP Address
Microsoft Network Group Settings
SMB
AFP
FTP
DLNA Server
iTunes
Downloader
WebAccess
Description
Operating in degraded mode.
Formatting the RAID array.
Checking the RAID array.
Creating the RAID array.
Rebuilding the RAID array.
Note: Transfer speeds are slower
during the rebuilding process.
Writing 0s to the RAID array and
erasing all data.
Formatting the drive.
Checking the drive.
Erasing the data for the drive.
The system is being initialized.
Updating the LinkStation
firmware.
Formatting the USB drive.
Data migration or conversion
(RAID migration) is in progress.
A new firmware version has been
released.
The backup job failed.
Corrective Action
-
-
-
-
-
-
Don't turn off the LinkStation.
Don't turn off the LinkStation.
-
-
-
Don't turn off the LinkStation.
Don't turn off the LinkStation.
Update the firmware.
Make sure that the backup job is configured
correctly, and that the NAS is on and not in standby
mode. If the backup job still fails, check the status
of the NAS, network, and the backup source and
destinations.
admin
"Public" and "admin" (for both Windows and Mac computers).
The LinkStation will get its IP address automatically from a DHCP
server on the network. If no DHCP server is available, then an IP
address will be assigned as follows:
IP Address: 169.254.xxx.xxx ("xxx" is assigned randomly when
booting the LinkStation.)
Subnet Mask: 255.255.0.0
WORKGROUP
Enabled
Disabled
Disabled
Enabled
Disabled
Disabled
Disabled
135