Bosch GOP18V-28 Operating/Safety Instructions Manual page 15

2610051959.qxp_GOP18V-28 9/28/18 10:02 AM Page 15
Accessory
OSL200CR
OSL350SD
Material
All wooden materials (e.g.,
hardwood, softwood, chipboard,
building board) Metal materials–
Metal materials, fiberglass
and plastics
Paint, varnish, filling compound
and filler
Sand Paper (White)
S A N D I N G
CG
- Wood
sanding
- Paint
finger
Sanding
backing
pad, - Depends on sanding sheet
series
Delta 3.5"
HCS - High Carbon Steel; BIM - Bi-Metal; CG - Carbide Grit.
Selecting Sanding / Grinding Sheets
For coarse-sanding, e.g. of
rough, unplanned beams and
boards
For face sanding and planing
small irregularities
For finish and fine sanding of
Sand Paper (Red)
wood
For sanding off paint
For sanding primer (e.g., for
removing brush dashes, drops
of paint and paint run)
For final sanding of primers
before coating
Material
Sanding wood or paint in hard to
reach areas without sanding
paper; example: sanding off paint
between shutter louvers, sanding
wooden floors in corners.
Sanding surfaces close to edges,
in corners or hard to reach areas;
depending on the sanding sheet
for, e.g., sanding wood, paint,
varnish, stone. Fleeces for
cleaning and for texturing wood,
removing rust from metal and for
keying varnishes, polishing felt
for prepolishing.
Application
-15-
Application
Grit Size
Coarse 40/60
Medium 80/120
Fine 180/240
Coarse 40/60
Medium 80/120
Fine 180/240