Sears Craftsman 113.20680 Owner's Manual page 26

WARNING: FOR:YOUR::OWN SAFETY, :TURN SWITCH
',OFF.: AND _REMOVE:: PLUG FROM POWER SOURCE
OUTLET BEFORE TROUBLE SHOOTING YOUR JOIN_
TROUBLESHOOTING CHART
,_ TROUBLE ,,,,,,,,,, _ , PROBABLE CAUSE, REMEDY
Motor will not run. 1. Defective On-Off switch. 1. RePlace defective parts before using
Defective switch cord.
Defective switch box receptacle.
2, Motor protector open, (only if
..... your motor is equipped with an
overload protector).
Other cause
.i i p_. _ i J i i i i
Wood strikes outfeed Bladesimproperly adjusted below
table after passingover surface of outfeed table.
cutter head; ......
Ripples on planed 1. one blade set higher than other.
surface.
2. Feeding wood too fast.
Planed surface not Infeed table out of adjustment.
straight.
=l ,.
Excessive gouging at end Bladesset too high above outfeed
of Cut,
90 ° and 45° cuts
inaccurate,
machine again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unlessrepair is done by a qualified service
technician. Repair service is available at your
nearest Sears Store.
H ,_J,
Re-adjust blades, see Maintenance section.
I. Re-adjust blades, see Maintenance
section.
2. Feed wood slower.
Re-adjust infeed table, see Getting To Know
your Jointer Planer section.
Reset blades, see Maintenance section.
table. :: ....
i _ 1, Fence stops not adjusted properly. 1. Re-adjust fence stops, see Getting To
_ " : ........ Know your Jointer Planer section.
2. Fence slide bracket not even with 2, Re-adjust slide bracket, see Getting To
table. : Know your Jointer Planer section.
LL JL : _ = I 'L =H
I
Infeed table loose. 1. Dovetail spacer requires adjustment,
Cutter guard does no;€ i t. Return spring broken, or spring
function proper_y, • has been weakened.
2. Improper assembly of spring or
guard rnounting.
1. Tighten screw, key 10, see fig. 2, Parts List.
screws, key 18, see fig. 2, Parts List.
t. Replace spring immediately. See
Maintenance section.
2. See Maintenance section.
RECOMMENDED ACCESSOR I ES
ITEM CAT. NO.
Steel Legs ............................... 9-22245
Floor Stand ............................. 9-22216
Cutter Blades .............................. 9-2293
Power Tool K now-how Handbooks
Radial Saw .............................. 9-2917
Table Saw .............................. 9-2918
Knife Setting Gauge ........................ 9-2647
The above recommended accessoriesare current and were
-available at the time this manuat was printed.
26