Craftsman 917.249491 Owner's Manual page 8

ASSEMBLY
MOUNTING TO TRACTOR (See Fig. 5)
Use Hardware - - GROUP "C"
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting assembly to
tractor
Raise seat on tractor to allow assembly to be mounted.
With cover closed, lift assembly and place support post
inside mounting bracket. Allow assembly to rest on
lanced tabs of mounting bracket.
Line up holes in mounting bracket with holes in support
post and insert bracket support pin Secure with re-
tainer spring
Unlatch and open cover.
Install the three (3) tubing end caps onto container
support
Tap each end cap onto container support tubes to seat
securely
COVER ASSEMBLY
RETAINER
SPRING
END CAP
SUPPOR"
LANCED TABS
MOUNTING
BRACKET
Fig. 5
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
• Place bottom half inside of top half, as shown
o Place one foot inside bottom half and lift top half to meet
bottom half
= Press halves tightly together while lifting top to lock into
place as shown
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET
° Repeat for second container.
CONTAINER
BOTTOM
HALF
PRESSTOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of corr-
tainer and check that there is no gap between upper and
lower halve& If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
f_
i _ _
,_- f,
Fig. 6
8