Accessories; Sensor Modules - Kaiterra Sensedge Getting Started

Accessories

The Sensedge may be shipped with the following accessories (dependent
upon region and order details):
Power cable and 2.4A, 5V adapter: Used to provide power to the Sensedge.
Never use an adapter or cable other than that shipped with the device.
Ethernet cable: The cable supplied with the device is optimised to fit inside
within the Sensedge's wall mount and allow cables to run directly into the wall.
Ethernet extension: Used to extend the Ethernet port outside of the device.
This may be necessary depending on the Ethernet cable used and the method
of installation.
Mini screw driver: Used to remove and attach the Sensedge wall mount from
the Sensedge body. The mini screw driver is not for use with the wall screws,
and should not be used to mount the device on a wall.
Wall screws (x3): Used to mount the Sensedge on a wall or vertical surface.
Miniature screws: Used to keep the outer case connected to the body of the
Sensedge.
Sensor modules: Used to measure a variety of pollutants and other parame-
ters, these sensors are interchangeable and modular.

Sensor modules

The Sensedge utilises a modular design to allow for easy control and replace-
ment of sensors. A CO2 sensor is built into the core of the device, and a variety
of other sensors may be inserted using the two sensor bays on the lower side
of the device.
To insert a sensor module, simply slide it into the bay, ensuring the Kaiterra
logo on the aluminium casing is facing upwards. When inserted correctly, the
module will click into place, and an LED light on the module's front will briefly
flash green.
To remove a module, gently push on the left side of it. The module will slide
further into the bay, before popping out. Do not push on the air intake/output
of a module to remove it.
Sensors may be inserted in either sensor bay, and in any order. They may be
swapped both when the Sensedge is powered on and operational, and when
the device is turned off.
By default, the Sensedge is shipped with the KM-100 and KM-102 sensor
modules, which together measure PM2.5, TVOC, temperature, and relative
humidity.