Mounting The Sensedge; Maintenance - Kaiterra Sensedge Getting Started

Mounting the Sensedge

The Sensedge may be used as a portable device, or mounted on a wall.
Mounting the Sensedge is done by first mounting the backplate to the wall,
using three screws. Once mounted, the main device may be inserted, by first
inserting the upper side, and then the lower side. Always remember to insert
and tighten the screw that holds the Sensedge closed when using the device,
and when wall mounting it.
Cables may be run down the wall, or run directly into the wall, through the
backplate.

Maintenance

The Sensedge contains no customer serviceable components, other than
the modules inserted in the two module bays. Neither the modules, nor the
Sensedge should never be opened, or unscrewed. Opening the Sensedge or
any of the modules immediately voids the warranty and may result in expo-
sure to laser radiation, which can cause eye injury.
The modular design of the Sensedge allows sensors with a limited lifespan, or
sensors requiring regular calibration and maintenance, to be easily replaced,
without the entire device being replaced.
Annual calibration of the device is not required, as each sensor module is
individually calibrated and tested at production.