Page 2
Mode, Smart Serial, SmartTel, Total Endurance, UNI/O, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies.
• Customer Support • Document Revision History DOCUMENT LAYOUT This document describes how to use the MCP1630 Automotive Input Boost Converter Demo Board. The manual layout is as follows: • Chapter 1. “Product Overview” – Important information about the MCP1630 Automotive Input Boost Converter Demo Board.
{ | } arguments; an OR selection RECOMMENDED READING This user's guide describes how to use MCP1630 Automotive Input Boost Converter Demo Board. The following Microchip documents are available and recommended as supplemental reference resources. MCP1630/MCP1630V Data Sheet, "High-Speed, Microcontroller-Adaptable, Pulse Width Modulator"...
Board provides a better choice for automotive application design and high efficiency. This chapter covers the following topics. • What is the MCP1630 Automotive Input Boost Converter Demo Board? • What the MCP1630 Automotive Input Boost Converter Demo Board Kit includes. LOAD Boost 36.5V / 400 mA...
The board also serves as a platform to evaluate the MCP1630/V devices. The MCP1630/V inputs were developed to be easily attached to the I/O of a microcontroller. The Microcontroller Unit (MCU) supplies the oscillator pulses and...
The PIC12F683 microcontroller is used to provide oscillator pulses at switching frequency of 500 kHz and set maximum duty cycle. The MCP1630/V devices generate duty cycles based on various external inputs. External signals include the input oscillator pulses from PIC12F683, the reference voltage and the feedback voltage.
MCP1630 Automotive Input Boost Converter Demo Board User’s Guide GETTING STARTED The MCP1630 Automotive Input Boost Converter Demo Board is fully assembled and tested for automotive input. The board requires the use of an external input voltage source (+9V to 18V) and external load.
Page 13
9V to 18V and checking the output voltage. Evaluating the Application The best way to evaluate the MCP1630 is to dig into the circuit and measure voltages and currents with a Digital Voltage Meter (DVM) and probe the board with an oscilloscope.
MCP1630 AUTOMOTIVE INPUT BOOST CONVERTER DEMO BOARD USER’S GUIDE Appendix A. Schematic and Layouts INTRODUCTION This appendix contains the following schematics and layouts for the MCP1630 Auto- motive Input Boost Converter Demo Board: • Board – Schematic • Board – Top Silk Layer •...
Need help?
Do you have a question about the MCP1630 and is the answer not in the manual?
Questions and answers